When you purchase your first Rebuildable
Atomizer, you need to know the basics of building your first coil.
Once you know the steps, putting them into practice should be easy enough.
Here is guide for newbies to building
coils.
Step-by-Step Beginners Guide to Rebuilding a Coil
Step#1: Gather
your coil building materials and tools. This includes a resistance wire, drill
bit, screw driver, a butane or propane torch, cotton wool, forceps, wire
cutters, iron and your e-liquid.
Step #2: Cutting
enough wire to wrap your coil. Ensure that the size of wire cut is enough to
work with. May be 6 to 8 inches.
Step #3: Wrapping
your wire round the drill bit so they touch each other. Keeping your coils
close to each other will ensure uniform distribution of heat when you fire your
device.
Step #4: Remove
your coil from the drill bit. It is important that you ensure your coils remain
closely touching each other. To do so, you can use forceps or pliers, and then squeeze
the coil to ensure they are touching. While doing this, be gentle and avoid applying
too much pressure because it might cause over-wrapping of the coil.
Step #5: Install
the coil. Here, you will insert the ends of your coil to your post holes. Then
use a wire cutter to trim the excess tag ends of your coil.
Step #6: Tune
the coil to heat uniformly. First, fire your mod and see how your coils heat.
If they heat uniformly, press the coils together with a pliers when still hot.
Final Step: Prepare
your wick by putting a thread of cotton wool through your wick and then tuck
the ends into the coil.
After that final step, your device is
ready to vape on. Just saturate your wick with your favorite e-liquid
and you are good to go. With time you will become an expert and avoid the tiny
mistakes in each step. At this point, building your own coils will not be work
but rather just an exciting way to achieve a superior vaping experience.
Leave a Reply